EAMIPAIR FC
Cement-based, Polymer Modified Thixotropic, Cosmetic Mortar for Concrete & Masonry Surfaces.
PRODUCT DESCRIPTION
EAMIPAIR FC is single component, polymer & fiber modified cementitious mortar for cosmetic, fairing and skimming of concrete and mineral substrates.
It contains Hydraulic binders, fillers, polymers, fibers, silica-fume and modifiers that permit the mortar to be applied in a thickness more than 3 mm. The hardened product exhibits an excellent thermal compatibility with concrete and outstanding waterproofing & weatherproofing properties.
PRODUCT DOCUMENTS
Technical Data Sheet
TYPICAL APPLICATIONS
EAMIPAIR FC is specially formulated to be used as polymer modified, high strength, non-sag waterproofing cementitious fairing & cosmetic mortar in:
-
Pore sealer, honeycombing and fishing coat upon mineral horizontal, vertical and overhead surfaces prior to application of decorative coatings.
-
As fairing and cosmetic coat to repair any surface defects.
-
On grade and below grade on concrete and mortar.
-
Levelling mortar preparatory to concrete to receive another protective coating.
-
Waterproofing & weatherproofing, fairing and cosmetic render up to 3 mm.
-
Where exceptional chloride and carbon dioxide resistance is required.
-
To provide a uniform surfaces free from defects over repaired areas.
-
All similar applications.
PRODUCT FEATURES
-
Easy to mix and apply.
-
Non-sag & non-shrink.
-
Excellent resistance to carbonation and water soluble salts.
-
Compatible with thermal coefficient of expansion of concrete.
-
Excellent abrasion resistance.
-
Extremely low permeability ensuring durability.
-
Very good resistance to water and waterborne soluble salts.
-
Non-toxic and does not contain any harmful ingredients.
-
Can be applied on horizontal, vertical and overhead surfaces.
-
Excellent resistance to freeze / thaw cycles.
-
Excellent adhesion to concrete and masonry substrates.
-
Smooth and easily produced cosmetic finish.
STANDARDS
EAMIPAIR FC is formulated to comply with all requirements of DIN EN 998 Part 1: “Specification for mortar for masonry, Rendering and plastering mortar”.