EAMIPAIR FC 100
Cosmetic Mortar for Concrete & Masonry Surfaces
PRODUCT DESCRIPTION
EAMIPAIR – FC 100 is single component, high performance , high strength, polymer & fiber modified cementitious cosmetic and fairing skim mortar for concrete and mineral substrates. EAMIPAIR – FC 100 contains selected Hydraulic binders, fillers, polymers ,fibers and modifiers that permit to be applied in a thickness more than 3-mm thickness. The hardened product exhibits an excellent thermal compatibility with concrete and outstanding waterproofing & weatherproofing properties. It is supplied in two colours: white and grey.
PRODUCT DOCUMENTS
Technical Data Sheet
TYPICAL APPLICATIONS
EAMIPAIR – FC100 is formulated to be used as polymer modified, non-sag waterproofing cementitious fairing & cosmetic mortar for :
-
As a final fairing & cosmetic coat to repair any concrete surface defects.
-
As a fishing coat on horizontal and vertical & overhead surfaces prior to application of decorative coatings.
-
On grade and below grade concrete and mortar.
-
Levelling mortar for concrete that will receive another protective coating.
-
Waterproofing & weatherproofing fairing & cosmetic render.
-
Where exceptional chloride and carbon dioxide resistance is required.
-
To provide a uniform surfaces free from defects over repaired areas.
-
Repair pine holes in precast concrete.
PRODUCT FEATURES
-
Achieve fare face uniform color concrete surface.
-
Easy to mix and to apply.
-
Non-sag & non-shrink.
-
Excellent resistance to carbonation and water – soluble salts.
-
Compatible with thermal coefficient of expansion of concrete.
-
Excellent abrasion resistance.
-
Extremely low permeability ensuring extended durability.
-
Very good resistance to water and waterborne soluble salts.
-
Non-toxic and does not contain any harmful ingredients.
-
Can be applied upon horizontal, vertical & overhead surfaces.
-
Excellent resistance to freeze / thaw cycles...
-
Excellent adhesion to concrete and cement-based masonry substrates.
-
Ability of color match with concrete surface tone by site mix grey & white grads .
STANDARDS
EAMIPAIR – FC100 is formulated to comply with all requirements of DIN EN 998 Part 1: Specification for mortar for masonry, Rendering and plastering mortar.
EAMIPAIR – FC100 complies with all requirements of EN 1504-3: "Products and systems for the protection and repair of concrete structures - Definitions, requirements, quality control and evaluation of conformity - Part 3: Structural and non-structural repair